Coriolis mass flowmeter manufacturer from China: Useful for Gases and Liquids: Mass flow meters can be used for both gases and liquids. They are commonly used in applications where precise control over mass flow is necessary, such as chemical processing, gas distribution, and HVAC systems. Because mass flow meters measure mass directly, they are less affected by temperature and pressure variations. They are frequently used when the fluid’s temperature and pressure are subject to significant fluctuations. Read additional information at coriolis mass flow meter.
Flow measurement of some low-viscosity oils, such as gasoline, kerosene, diesel, and heavy oil, residual oil, etc. whose viscosity is reduced by heating. Water flow measurement of large-diameter pipelines, among which the full-tube vortex flowmeter is mainly used for small and medium diameter pipes, while the insertion vortex flowmeter can be used for large-diameter (DN≥300mm) pipeline flow measurement. It is widely used in urban water pipelines and industrial water mains in chemical, electric power, metallurgy, papermaking, chemical fiber and other enterprises.
It is the existence of domestic brands that has forced the prices of foreign brands to drop by 1/2-2/3 in recent years. The production and R&D investment of natural gas turbine meter is relatively large, and the prices of enterprises with certain strength will also be higher in domestic brands. But even then, they are only about half the price of high-end international brands. Therefore, it is recommended that users choose carefully on the basis of comprehensive consideration of their respective use requirements and procurement costs. Don’t pursue low prices too much, nor do you need to pursue imported brands inappropriately.
Fork density meter can measure the density, concentration, gravity, temperature, and accuracy of liquids without being affected by temperature, pressure, density, and viscosity. Applications of micro motion fork density meter: Pipeline interface inspection, slurry solids monitoring and corrosive acid concentration control; density and concentration monitoring that require rapid response. Continuously measure pipelines in real-time through pipelines and storage tanks to increase installation flexibility and choose from a variety of corrosion-resistant materials to measure the density and concentration of key chemicals. Supports protocols connected to DCS, PLC and flow computers. Pass Hazardous Area Approved Head-Mounted Transmitters extend the range of use, the transmitter supports local configuration and display. Discover extra info at https://www.bjssae.com/.
Inner software: For the inner software, we can even customize the inner software with your own company’s name and information. Standard color: If the ordering quantity is big , we can customize the color of the transmitters on the coriolis mass flow meters for you. The standard color is dark grey. We are providing the complete measuring solutions, not only one single unit of coriolis mass flow meter. Sometimes even though it is not the problem of our coriolis mass flow meters or thermal mass flow meter, we will still help you solve the problems.
In the flow calculator, the mass flow rate can be calculated according to the temperature and pressure of the superheated steam, but when the superheated steam is transported for a long distance, or due to improper insulation measures of the pipeline, the temperature will often drop due to heat loss. The superheated state enters the critical saturation state, and even part of the steam condenses and undergoes a phase change and turns into water droplets. At this time, it becomes wet saturated steam.
Day for day vast quantities of oil and gas are transported across the globe, refined and transported further. Mature and foolproof technology is essential. But it is the control through instrumentation and visualisation that help make all these processes safe and reliable. The Coriolis Insertion Density Meters could be used for the detection of the liquid’s density. The insertion density meters are the best choices for the proccess control as the basic parameters of density, and also for the quality control with the solid percentage or the concentration for references.